Nylon 6 fiber media를 이용한 Biofilter의 VOCs(Toluene)의 제거

김장호,최동훈,김종수,김형호,장봉수 동아대학교 환경문제연구소 2002 硏究報告 Vol.25 No.1

This study was investigated the application and kinetics of biofiltration using cometabolic process to remediate gaseous toluene that are highly recalcitrant to adsoption and biodegradation. Biofiltration was successfully applied to treat amixture of volatile organic compounds(Toluene) from contaminated air stream. Immobilized Ps.oleovorans biofilter was evaluated for its value in simultaneous removal of Toluene from waste air stream. In the loading rate (1,000ppm) and space velocity(1,200hr). the average removal efficiencies of Toluene were 33.7%. and CO2 production rate were 5.28㎎/hr

충진탑에서 가스흡수에 의한 물질전달과 수력학적 거동에 관한 연구

최동훈,김재홍,김일배,김옥택,김장호 동아대학교 환경문제연구소 1997 硏究報告 Vol.20 No.1

The use of packed column which apply efficient thermal material separation method has been required for absorption process. Absorption is applicable to waste gas from industrial process and incineration and odor control. Since we have used the lattice packing which was recently discovered in Germany, We can prevent drop of efficiency from maldistribution and channeling which were occurred when we use conventional packing. The lattice packing is efficient within the range of thermal, easy to manufacture, low production cost and make a variety of materials. This study aims to control the waste gas and odor with absorption. The dimension of packed column in which used in experiment is 0.45(d) × 2.0 m(H), and the result of and mass transfer apply to practical industry and environmental protection. The systems adopted for the absorption are Air/Water and NH3-Air/Water. We still cannot apply packed column to the domestic industry and environmental protection and depend on foreign technology, but this study will contribute to the industry and environment.

석탄을 원료로한 활성탄 제조와 흡착특성에 관한 연구

최동훈,김형호,김종수,김재홍,김장호 동아대학교 환경문제연구소 2001 硏究報告 Vol.24 No.2

The purpose of this study is develop manufacture technology of activated carbon for purification of water, it is investigated suitable manufactures for manufacture of activated carbon for purification of water by use anthracite coal and bituminous coal produced in internal and external through this fact, economic valuation and made method established. it is valuated wether or not suitable high degree purification by know removal characteristic organic matter such as KMnO₄Consumption, DOC, UV-254, and THMFP make use of Pilot-plant (purification of water treatment) for made activated carbon. For mixed anthracite coal and bituminous coal by means of coal tar pitch, completely melt to fixed coal tar pitch apply l50℃ heat at stainless steel box, since then compounding weight rate 1:l of anthracite coal and bituminous coal sieved material, then add coal tar pitch and caking water, mixed suitable compounding rate since then extrude and mix by diameter 5.5m extruder, extruded mold cute and dry length l0mm pellet shape by cutter and then made activated carbon.

40세 이하 관상동맥 질환자에서 장기적 임상 관찰

이승욱,정명호,박종철,박형욱,조상희,김원,김계훈,이상현,강경태,조장현,김남호,김건형,안영근,조정관,박종춘,강정채 全南大醫大 2001 전남의대학술지 Vol.37 No.2

현대건축에 있어서 脫定型的 공간구성의 多義的 표현에 관한 연구

장훈익,김영태 대한건축학회 2004 대한건축학회논문집 Vol.20 No.2

This study is about ex-formal types of spatial composition. There are five types of various space expression of contemporary architecture with concept of ex-formal. They are dynamic form composition through plasticity of concrete, disposal spatial composition by geometric collision and geometric superimposion, deconstruction formal composition through form dismantle, ex-cubic spatial composition through folding and free formal composition by digital technology. Also, there are some elements express ex-formality spatial composition for each type. To begin with, they are plasticity, totality and dynamism in dynamic form composition through plasticity of concrete, they are interpenetration, dispersibility in the second type, temporality, fragment, destruction in the third type and obliquity, inclination, bending in the fourth type. Finally, they are fluidity, nonlinearity, plasticity, organic character, continuity in free formal composition by digital technology. Therefore, this study aims to help understand tendency of various space expression in contemporary architecture through searching how to express type of ex-formal spatial composition and polysemous expression character in building since 1960's.

일차적 관동맥 중재술 시 관동맥 조영술상 혈전이 많은 병변에서의 원위부 색전증 방어에 대한 PercuSurge GuardWire 시술의 유용성

김장영,윤정한,이승환,유병수,정현숙,김우재,주헌수,황성오,최경훈 대한순환기학회 2003 Korean Circulation Journal Vol.33 No.12

Dumped and Structured Packing을 이용한 알콜/물 증류

김석택,최동훈,김재홍,김장호,빌렛 라인하르트 동아대학교 환경문제연구소 2000 硏究報告 Vol.23 No.1

In this study, the diagrams for various packing shown given an impression of the effectiveness of several fraction device for separation towers in alcohol distillation. The results obtained are presented under the aspect of showing the effect of design parameters such as e. g. weir height, opening ratio, tray columns, or size of packing elements, relative void volume and surface quality for packed columns, as well as the effect of process parameters such as operating pressure, reflux ratio and phase load of the separating column. The relevant technical literature provides comprehensive information for fluid dynamic computations as well as for predetermining the separation efficiency of columns working under industrial operating conditions, this applies to tray columns and packed columns equally. The most recent computation models of thermal separation technology allow the quantitative valuation also of other efficiency when used in industrial alcohol distillation plants, and the corresponding dimensioning of columns with an accuracy that is sufficient for the requirements of practice.

學校周邊 道路交通 騷音과 學生 聽感反應과의 相關關係 硏究

김종수,최동훈,박진식,김석택,김장호,서정민 동아대학교 환경문제연구소 1997 硏究報告 Vol.20 No.2

For my thesis I have analyzed the differences between the traffic noise level surrounding the schools and the perceived level of noise. I have used the ways of measurement and questionnaires to support my study. According to the analysis, the measured noise level was higher than the expected noise level. The equivalent noise level was proven to be higher when the windows of the classrooms were open. The noise level was also higher on the third floor than the first floor. The correlation between the measured noise level and the perceived level of noise was tested in each school. The school which had a higher expected noise level showed a high perceived level of noise. The measured noise level and the perceived level of noise became larger on the higher floors. Through the questionnaires, the traffic noises were proven to be the largest noise-making source surrounding the schools. Most of the students replied on the questionnaires that they have been consistently bothered by the noise. It interfered with their studies and concentration. Also, the sound of their voices became louder because of the noise around their schools. Therefore, I have come to the conclusion that the traffic noises that surround the schools give the students negative influences.

하악전돌증에서 하악지 시상분할골절단 및 Screw고정후 골성회귀에 관한 연구

김명래,최장우,윤정훈,이창국 大韓顎顔面成形再建外科學會 1996 Maxillofacial Plastic Reconstructive Surgery Vol.18 No.4

Skeletal and dental changes were examined in 38 patients of mandibular prognathism who been treated by a bilateral sagittal split osteotomy(SSRO) and internal fixation using titanium mini-screws. All patients were followed up for over 8 months after the surgeries, and postoperative cephalometric measurements were compared at 2 months and at 8 months. Linear measurements of the “Pog-most posterior screws” and angular measurementsts of “SN-Pog”were compared to figure out the change of bony fragments. The significancy of data were tested by unpaired T-test. The results were as follows : 1. The fixation screws were changed in cephalometric position as little as 0.32 2.51㎜ in SSRO and 0.15 1.00㎜ in SSRO & Le Fort I Osteotomy.(P<0.05) 2. Mandibular set-back over 5㎜ resulted in less stability of the fixation screws and higher relapse tendency. 3. The internal fixation using two screws along the inferior border and one on the superior ridge is considered to be very resistant to postoperative relapse of the repositioned bony segments.

부산 신평·장림공단지역의 대기오염물질 배출 특성

김상헌,정장표,김영태,조성훈 慶星大學校 環境問題硏究所 1995 環境硏報 Vol.5 No.1

Industrial growth and urban gravitation of the population etc. have seriously deteriorated the air quality which has adverse effect on human health and property, and the situation is more serious in industrial complex as well. Therefore, it is necessary to examine the pollutants emissions inventory to establish proper and comprehensive strategies for the reduction of pollutant levels. This study is aimed at investigating the characteristics of the pollutant emissions in the vicinity of Sinpyeung·Jangrim industrial complex in Pusan. The emission quantities of air pollutants were estimated by the grid(1㎞x1㎞), the source classification, and the time on the basis of the type and the amount per month of the fuel. The important results from this study were as followings: The average emission quantity(rate) of SO₂, TSP, NOx, CO and HC showed 1926.74 ton/yr(61.09 g/sec), 367.83 ton/yr(11.66 g/sec), 1440.64 ton/yr(45.68 g/sec), 4698.33 ton/yr(148.98 g/sec) and 447.15 ton/yr(14.18 g/sec), respectively. In case of SO₂and TSP, the emission quantities were majorly contributed by stationary source(point source and area source) whose contribution percentages were calculated as 65.8%, 30.6%. On the other hand, emission quantities of NOx, CO and HC were highly contributed by mobil source(line source) whose contribution percentages were calculated as 59.3%, 84.2% and 88.6%.