http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
梁均懿,남궁석 충남대학교 공업교육연구소 1980 論文集 Vol.3 No.2
The cutting resistance of grooved and non-grooved workpieces and the tool life under various cutting conditions was investigated experimentally with the use of a tool dynamometer. The results of this experiment are as follows : 1) The cutting force (principal and feed forces) increases with increasing depth of cut due to the force of the impact (force) between tool and workpiece in interrupted cutting. 2) The tool life of a P 20 cutting tool reduces with increasing feed cutting speed, and number of grooves. 3) The life of a P 20 tool is exceedingly short by comparision to the tool life of a H.S.S. tool in proportion to the increase of number of grooves.
NC 가공을 위한 Ferguson 곡면의 오차 해석에 관한 연구
梁均懿,張鐘聲 全北大學校 1990 論文集 Vol.32 No.-
Sculputured surface are widely found in car body, ship hull and air plane parts. This paper covers computer-aided design of soulptured(or free-form) surface ; surface interpolation methods ; methods of generating CL-data for the machining of 3-D sculptured surface. The purpose of this paper is aimed to express how much we could show the real surface accurately comparing with the Ferguson surface used so many times, which is abtained from the 3-D point data through engineering calculation.
다구찌 실험 계획법을 이용한 고속가공에서 공구수명 조건의 최적화
양균의,임표 한국기계가공학회 2006 한국기계가공학회지 Vol.5 No.4
High Speed Machining(HSM) reduces machining time and improves surface accuracy because of the high cutting speed and feedrate. Development of HSM makes it allowable to machine difficult-to-cut material and use small-size-endmill. It is however limited to cutting condition and tool material. In the machining operation, it is important to check main parameter of tool life and select optimal cutting condition because tool breakage can interrupt progression of operation. In this study, cutting parameters are determined to 3 factors and 3 levels which are a spindle speed, a feedrate and a width of cut. Experiment is designed to orthogonal array table for L9 with 3 outer array using Taguchi method. Also, it is proposed to inspect significance of the optimal factors and levels by ANOVA using average of SN ratio for tool life. Finally, estimated value of SN ratio in the optimal cutting condition is compared with measured one in the floor shop and reduction of loss is predicted.