http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
강호양 한국목재공학회 1994 목재공학 Vol.22 No.1
To increase drying rate and reduce drying degradation, pretreatments such as prefreezing and presteaming have been widely used in wood industries. Presteaming lumbers prior to kiln drying is known positively to improve its permeability, to increase diffusion coefficient and to reduce discoloration, but negatively to increase collapse. Prefreezing lumbers prior to kiln drying is also known to reduce significantly its drying defects and its shrinkages. Thus it is no doubt that the pretreated lumbers shrink diversely from the untreated. In this study the shrinkage behaviors of the pretreated specimens are investigated by drying two tropical hardwoods (Apitong and Taun) in three different dying conditions: high temperature and slow drying rate (drying in a closed cylinder), high temperature and rapid drying rate (drying in an oven) and low temperature and slow drying rate(drying at room temperature). The prefrozen specimens show the least volumetric shrinkages in most drying conditions. The specimens dried in cylinders shrink most among all drying conditions. In general the pretreated specimens reached the 30% moisture content faster than the untreated by about 30%.
국산 굴참나무와 졸참나무의 물리적 성질 - 생재비중 및 섬유장 비교
강호양 한국가구학회 2004 한국가구학회지 Vol.15 No.1
Domestic oak trees of Quercus variabilis and Quercus serrata were harvested from several forest sites and their green moisture contents, green specific gravities and fiber lengths were compared. The green specific gravities of Quercus serrata trees showed differences between the forest sites at 5% significance level while those of Quercus variabilis didn't. In the radial direction the green specific gravities of Quercus variabilis gradually increased from pith to bark. There was no discrepancy of the green specific gravities between the sapwood and heartwood of Quercus variabilis. And no difference of fiber length was found between individual trees and tree heights for both species.
강호양,김수원 충남대학교 농업과학연구소 2004 농업과학연구 Vol.31 No.1
This study was carried out for deresinning the larch boards dried in a conventional kiln. Prior to heat treatment they were steamed in an autoclave for 5 hours or frozen for 24 hours at a temperature of -35℃. The velocities of ultrasound transmitted through the specimens were measured to examine the correlation with their resin contents. It was found that the specimens heated at 100℃ for 5 hours contained less resin that those heated at 200℃ for an hour. Both treatments of steaming and freezing were effective for deresinning and the former was better than the latter. The ultrasonic velocities measured before the heat treatment showed a negative correlation to the resin contents of the specimens, but those measured after the heat treatment a positive correlation. This difference may be attributed to the viscosity of resin.
주성분 분석을 이용한 목재 건조 중 발생하는 음향방출 신호의 해석 및 분류
강호양,김기복 한국비파괴검사학회 2003 한국비파괴검사학회지 Vol.23 No.3
본 연구는 목재(참나무 판목 판재) 건조 중 발생하는 음향방출 신호에 대하여 목재 내 수분이동에 의한 신호와 표면할열에 의한 신호를 해석하고 분류하기 위하여 수행되었다. AE 신호의 특징값들에 대한 상관분석을 실시하여 상호의존성이 높은 변수를 제거한 후 주성분 분석을 실시하였다. AE 변수들을 독립변수로 한 분류기와 주성분들을 독립변수로 한 분류기에 대하여 분류성능을 비교하였다. 목재 건조시 발생하는 표면할열과 수분이동에 따른 AE 신호 파형을 분석한 결과 대체적으로 표면할열에 의한 신호가 최대진폭이 크며 상승시간이 짧고 상대적으로 고주파의 신호인 것으로 분석되었다. 다중 회귀분석모델을 이용하여 수분이동에 의한 신호와 표면할열에 의한 신호를 분류할 수 있는 분류기를 개발하고 평가한 결과 개별 AE 변수들을 독립변수로 하는 분류기 보다 주성분들을 독립변수로 하는 분류기의 분류성능이 양호한 것으로 나타났다. In this study, acoustic emission (AE) signals due to surface cracking and moisture movement in the flat-sawn boards of oak (Quercus Variablilis) during under the ambient conditions were analyzed and classified using the principal component analysis. The AE signals corresponding to surface cracking showed higher in peak amplitude and peak frequency, and shorter in rise time than those corresponding to moisture movement. To reduce the multicollinearity among AE features and to extract the significant AE parameters, correlation analysis was performed. Over 99% of the variance of AE parameters could be accounted for by the first to the fourth principal components. The classifiers having six independent variables (AE parameters) and six principal components. As a result, the statistical classifier having AE parameters showed the success rate of 70.0%. The statistical classifier having principal components showed the success rate of 87.5% which was considerably than that of the statistical classifier having AE parameters.
강호양 한국목재공학회 1995 목재공학 Vol.23 No.3
The presteamed or prefrozen persimmon blocks of 10㎝ × 10㎝ × 15㎝ were air-dried at. room temperature until about 30% moisture content, and then were dried in a MW oven. During drying their internal temperatures were monitored with thermo-couple probes. The presteamed and prefrozen blocks didn't show any improvement in drying rate and moisture gradient when compared with the controls. Checks appeared on the surfaces of most presteamed blocks during air-drying. It has been clearly revealed that the maximum weight loss must. be less than 2g/min during MW drying to prevent internal checking and that MW drying reduced moisture gradients inside blocks. MW dried the persimmon blocks 440 times faster than conventional kiln.
Effect of Pretreatments and Drying Methods on Abnormal Shrinkage of Wood
강호양,이민경 한국가구학회 2008 한국가구학회지 Vol.19 No.4
Collapse is an abnormal shrinkage resulting in uneven, rough surfaces and/or warping of sawn timber. The maximum abnormal shrinkages of the oak and persimmon specimens were obtained by the quasi-equilibrium drying and were compared with the other drying methods. The effect of steaming and freezing treatments on the shrinkage of wood was also investigated. The Quasi-equilibrium drying used in this study was proved as a good tool to make the maximum abnormal shrinkage of wood. The maximum abnormal volumetric shrinkage possibly caused by collapse could be 16.3% and 14.3% for the oak and persimmon specimens, respectively. In general the steaming-treated specimens shrank less than the controls for the oak specimens, but did more for the persimmon specimens. The volumetric shrinkages of the freezing-treated specimens were more various between the drying methods than those of the control and steaming-treated specimens.