http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
유재택 대한전자공학회 1996 CAD 및 VLSI 설계연구회지 Vol.5 No.1
VLSI chips suffer from exaggerated clock skew problems when the clock rate reaches several hundred MHz. To solve these problems, we, propose the use of counterflow-clocking in which the clocks are distributed in a direction opposite to the data flow direction by employing hack-propagating clock signals amplified b5 a chain of inverters. This paper introduces Counterflow-Clocked(C²) Pipelining and discusses its usefulness and limitations to build large and high speed VLSI chips. It also presents the design of an image compression chip set to implement subband vector quantization that can handle HDTV data rates with reasonable VLSI chip sizes, The major advantages of this new pipelining are: easier distribution of high speed clocks, shorter clock period due to the absence of global clock signals, natural use of dynamic latches, less internally generated noise due to uniformly distributed latch operations, etc. Composition methods were developed. The use of these methods enabled us to build a system with two-dimensional data-flow in C² pipelining employing a tree of inverter chains fer clock distribution. C² pipelining was used to design an IDTV chip set with several design innovations, demonstrating the applicability and viability of the technology.
유재택 안양대학교 산업기술연구소 2001 自然科學硏究 Vol.8 No.-
실시간신호인 전력계통 보호계전기중 송전선보호용 CR(Carrier Relay) 신호는 전송선로 양단간에서 4msec이내의 전송지연시간 및 160μsec 이내의 양방향 전송지연시간차를 요구한다. 본 논문에서는 전력계통에 포설된 광섬유인 OPGW(Overhead comPosite Ground Wire)를 이용한 ATM망 구축시의 전송 기본모델을 정하고 CR용 B-TA(Broadband Termianal Adaptor)의 사양을 결정하였다. 이러한 B-TA와 일반 공중통신망용 장비와 틀린점은 ATM cell 조립에 partial-fill 방식을, cell 손실 대책으로 Fast SN 알고리즘 및 error시 dummy cell 생성 방식을, CDV(Cell Delay Variation) 흡수 및 통신 신뢰도 향상을 위하여 적응 clock 법의 채택 등이다. 제작된 B-TA 쌍을 시험한 결과 전송지연시간이 최대 1.85msec이고 전송지연차시간이 최대 90μsec로서 CR 신호의 전송요구조건을 만족하는 결과를 보여 주었다. Real time CR (Carrier Relay) signal for the protection of power line requires transmission delay time of less than 4 msec between two end points of a transmission line and bidirectional transmission-delay-time difference of less than 160μsec. This paper draws a basic model of transmission when we construct ATM network using OPGW(Overhead comPosite Ground Wire) which is installed over power line system, and decides the specification of B-TA(Broadband Terminal Adaptor) for CR. The differences between this B-TA and an equipment for public communication network are the adoption of partial-fill method for ATM cell assembly, the application of fast SN algorithm and dummy cell generation method with errors for cell loss countermeasure, and the adoption of adaptive clock method for the absorption of CDV(Cell Delay Variation) and the improvement of communication reliability, etc. The experimentation using fabricated B-TA pair resulted in maximum transmission-delay-time of 1.85msec and maximum transmission-delay-time difference of 90μsec. These results satisfy the transmission criteria for CR signals.
AYM망에서 ABR 서비스의 공정 대역폭 할당을 위한 퍼지 전송률 제어 기법
유재택,김용우,김영한,이광형 한국통신학회 1997 韓國通信學會論文誌 Vol.22 No.5
본 논문에서는 ATM 네트워크에서의 접속된 ABR 서비스에 대해 공정한 대역폭을 할당하는 새로운 비율 기반 전송률 제어 알고려즘을 제안한다. 기존 ABR 서비스에서는 일정률로 전송률을 증가, 감소를 하면서 대역폭을 할당하나 제안된 알고리즘에서는 이용 가능한 대역폭을 퍼지 추론을 하여 접속된 호에 대해 전송률을 공평하게 분할하는 기법이다. 퍼지 추론은 입력 변수로 버퍼 상태, 버퍼 변화율을 사용하고 출력 변수로 전체 전송률을 사용한다. 이 추론된 결과값은 동작 중에 있는 ABR 서비스 호에 공평하게 분배되어 진다. 모의 실험 결과 기존의 E EPRCA 방식보다 제안된 방식이 링크 효율면에서 RIF, RDF가 1일 경우 0.17%, 1/4 경우 6%, 1/16 경우 38.6%, 1/32 경우 82.4%의 향상을 보였다. In this paper, we propose the new rate-based transmission rates control algorithm that allocates the fair band-width for ABR service in ATM network. In the traditional ABR service, bandwidth is allocated with constant rate increment or decrement, but in the proposed algorithm, it is allocated fairly to the connected calls by the fuzzy inference of the available bandwidth. The fuzzy inference uses buffer state and the buffer variant rate as the input variables, and uses the total transmission rate as a output variable. This inference a bandwidth is fairly distributed over all ABR calls in service. By simmulation, we showed that the proposed method improved 0.17% in link effectiveness when RIF, RDF is 1/4, 38.6% when RIF, RDF 1/16, and 82.4% when RIF, RDF 1/32 than that of the traditional EFPCA.