http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Mohammad Omar Faruk Murad,Zamri Chik,B. M. Nural Absar,Kamal Hossain Shikdar,Khairul Anuar Mohd Nayan 대한토목학회 2016 KSCE Journal of Civil Engineering Vol.20 No.6
In this study a full scale 3D analysis of post-tensioned box section and pre-tensioned inverted T-girder section is carried out by considering only vertical loadings. The aim of this research is to investigate long span box Girder Bridge with pre-tensioned inverted T-girder using splicing technique. 4 lanes of 150m long (3 spans @ 50 m) post-tensioned box girder bridge with 12 cells and 13.54 m wide deck is considered as the bridge model and that the equivalent box section consists of 13 numbers of inverted pre-tensioned girder having two different lengths spliced at the points of inflection of continuous length of the bridge. The inverted T-girders are used to support the deck panel with superimposed load on it. The structural analysis of the bridge is done using CSi Bridge employing Integrated 3D Bridge Design Software based on finite element method for both longitudinal and transverse direction. In the analysis, AASHTO LRFD-2006 is used by subjecting Uniformly Distributed Load (UDL), edge loads, knife edge loads, and heavy vehicles load on the bridge deck. Moving vehicles load is placed at different locations to determine the maximum and minimum moments, stresses and flexural effects. Actual post-tensioned box section flexure, shear, torsion and stress in both longitudinal and transverse analyses showed lower values when compared to pre-tensioned inverted T-girder section. Assuming monolithic behaviour, the actual box section provided better stiffness rather than equivalent one. Nevertheless composite behaviour of the equivalent section can be accepted as an alternative solution for long span continuous box Girder Bridge where cost is a major factor in particular.