http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
PN부호의 동기추적을 위한 비코히어런트 TDL에서 최적의 BPF 대역폭
송문규,최흥택,차균현 한국통신학회 1994 韓國通信學會論文誌 Vol.19 No.8
본 논문에서는 비코히어런트 방식의 시간분할 조만 동기추적루프에 속하는 타우진동루프의 최적 설계를 위한 대역통과필터의 대역폭에 대하여 고찰하였다. NRZ 데이터의 경우 이상적 대역통과 필터를 채용한 비코히어런트 TDL의 제곱손실 및 최소의 동기추적지터를 구하였다. 또한 이를 이용하여 최적의 3dB 대역통과필터 대역폭을 주어진 데이터율과 데이터 신호대잡음비에 대해 계산하였다. 결과로서 이상적 대역통과 필터의 경우 최적의 대역폭은 주어진 신호대잡음비에 따라 데이터율의 약 1-2배의 범위 내에 존재함을 알 수 있었다. The optimum design and performance of noncoherent TDL considering the effect of distortions due to the IF bandpasss filters are described. NRZ data and ideal filter is presumed in the simulation. The optimum filter bandwidth is calculated in the sense of minimizing the loop's squaring loss, which is equivalent to minimizing the loop's tracking jitter for a given data rate and data signal-to-noise ratio. As a result, the optimum filter bandwidth depends on the signal-to-noise ratio, and is obtained in the range of about 1-2 times of the data rate.
강상기,최흥택,Kang, Sang-Gee,Choi, Heung-Taek 한국정보통신학회 2009 한국정보통신학회논문지 Vol.13 No.6
교량감시, 문화재감시, 하천감시, 노약자보호, 도시관제 및 환경감시 등 많은 분야에서 USN(Ubiquitous Sensor Network)을 이용한 서비스가 시작되고 있고, USN을 구현하기 위해서는 RF 송수신기가 반드시 필요하다. 본 논문은 2.4GHz 대역에서 동작하는 센서노드용 RF 송수신기의 설계 및 제작에 대해서 기술한다. RF 송수신기의 설계과정으로 AGC의 범위 설정과 송수신기의 설계 과정이 기술되어 있다. 또한 설계된 RF 송수신기를 제작하여 성능을 시험하였으며, 수신감도, 동작범위, 주파수 안정도, 위상잡음, 송신전력, 송신대역평탄도와 스펙트럼 마스크의 측정 결과가 기술되어 있다. USN(Ubiquitous Sensor Network) is used to provide many services such as bridge monitoring, cultural properties monitoring, river monitoring, protection of an old and feeble person, management and control of a city and circumstance monitoring, etc. A RF transceiver is needed for implementing USN. In this paper the implementation and the design of a RF transceiver for sensor nodes operating in 2.4GHz frequency band are presented. The design procedure of AGC, a receiver and a transmitter is described. And the performance of the implemented RF transceiver is also tested. The test results of receiver sensitivity, receiver dynamic range, frequency stability, phase noise, output power of transmitter, flatness and spectrum mask are presented.
Baatarkhuu Dorjsuren,최흥택(Choi, Heung-Taek),안달(Ahn Dal) 한국산학기술학회 2009 한국산학기술학회논문지 Vol.10 No.6
본 논문에서는 T-접합선로의 집중소자 등가회로를 고려한 저역통과 여파기를 제안하였다. 일반적인 저역통과 여파기 설계 시 발생하는 T-접합선로의 특성에 따른 주파수 변이 특성을 해결하기 위해 T-접합선로 등가회로의 소자 값을 구하는 수식을 유도 하였다. 또한, 전자장 시뮬레이터(HFSS)를 이용하여 T-접합선로를 디임베딩하였다. 이로써 선로의 임피던스 허수값들이 일치되게 하여 T-접합선로 등가회로에서 집중소자의 정확한 값을 구하였다. 그리고 이 값들을 이용하여 저역통과 여파기를 설계한 결과, 집중소자 여파기의 주파수 특성과 분포소자 여파기의 주파수 특성이 매우 잘 일치함을 확인할 수 있었다. In this paper, the Low Pass Filter (LPF) using the equivalent circuit of T-junction microstrip line is proposed. And we derived the formulas for lumped-elements of the equivalent circuit of T-junction microstrip line to solve the frequency shift characteristic. T-junction microstrip line is de-embedded by Electromagnetic simulation tool and exact lumped element value of T-junction microstrip line is calculated by the equation of Z-parameter. We can get excellent agreement between lumped-element LPF frequency response and transmission line LPF frequency response.
정치현(Jung, Chi-Hyun),윤화영(Yoon, Hwa-Young),박광식(Park, Kwang-Sik),임종식(Lim Jong-Sik),최흥택(Choi, Heung-Taek),안달(Ahn Dal) 한국산학기술학회 2009 한국산학기술학회논문지 Vol.10 No.4
본 논문은 구로다 저역통과여파기의 개방 스터브에 결함 접지 구조(Defected Ground Structure; DGS)를 적용한 새로운 구조를 제시하였다. 이를 위하여 130ohm의 특성 임피던스를 갖는 개방 스터브에 DGS를 삽입한 등가 구조를 구하였다. 이 방법은 선로의 폭을 확장하여, 구현이 어려운 구로다 저역통과여파기의 제작을 가능하게 하였다. 130ohm의 개방 스터브는 비유전율 4.8, 기판의 두께 0.7874mm인 기판에 구현할 때 선폭이 0.1mm 이하로 구현되어야 하는데, DGS를 삽입하여 0.5mm의 폭으로 5배 이상 확장하였다. 이를 적용한 5단 구로다 저역통과여파기는 설계와 측정 결과가 매우 잘 일치함을 보여 주었다. This paper presents a new open stub structure of Kuroda low-pass filter using DGS(Defected Ground Structure). The open stub having 130ohm is made with equivalent new structure using DGS. This method enable to the fabrication of Kuroda low-pass filter by extending width of the line. In case of FR4(er=4.8, h=0.7874mm), the width of open stub(130ohm) is under 0.1 mm. But, the width of open stub using DGS can extend to the width of 0.5mm. 5th order Kuroda low-pass filter design using open stub with DGS shows excellent agreement between theoretical simulation and experimental results.
광대역 특성을 갖는 N-way 저항성 전력 분배기 설계
강민기(Kang, Min-Ki),백승호(Baek, Seung-Ho),이소현(Lee, So-Hyun),장대훈(Jang, Dae-Hoon),임종식(Lim Jong-Sik),최흥택(Choi, Heung-Taek),안달(Ahn Dal) 한국산학기술학회 2009 한국산학기술학회논문지 Vol.10 No.5
본 논문에서는 광대역 특성을 갖는 N-way 저항성 전력 분배기 설계에 대하여 기술하였다. 이를 위하여, 종래의 3-way 저항성 전력 분배기를 기본으로 N-way 저항성 전력 분배기의 설계식을 유도하였다. 유도된 설계식의 타당성을 입증하기 위해 7개의 출력으로 동일한 전력을 분배하는 8-way 저항성 전력 분배기를 설계하고, 제작된 저항성 전력 분배기의 측정결과를 관찰하였다. 제작된 저항성 전력 분배기는 DC부터 약 3GHz까지의 광대역에서 균등한 전력 분배 비율을 보였고, 반사손실 또한 약 -25dB로 우수한 특성을 나타내었다. In this paper, N-way resistance power divider is described for wideband frequency characteristic. For this, we derived in design equation of a N-way resistance power divider using 3-way resistance power divider. We designed 8-way resistance power divider that can divide same power by 7 output and measurement result of fabricated resistance power divider is observed to prove the validity of derived design equation. Fabricated resistance power divider shown equal power division ratio and reflection loss displayed excellent characteristic by about -25dB in broadband from DC to 3GHz.
하정현(Ha, Jung-Hyen),신은영(Shin, Eun-Young),강민우(Kang, Min-Woo),권칠현(Gwon, Chil-Hyeun),박병훈(Park, Byung-Hoon),임종식(Lim Jong-Sik),최흥택(Choi, Heung-Taek),안달(Ahn Dal) 한국산학기술학회 2009 한국산학기술학회논문지 Vol.10 No.6
본 논문에서는 통과대역을 가변하는 대역통과여파기를 제안하였다. 이 여파기의 구조는 2단 Direct Capacitive Coupled 공진기 대역통과여파기이며, 중심주파수의 가변을 위하여 여파기에 사용된 병렬 공진기의 캐패시터를 버렉터 다이오드로 대체하였다. 본 논문에서는 중심주파수 200MHz에서 최대 245MHz까지 가변되는 대역통과여파기를 제작하여 설계 이론의 타당성을 검증하였다. This paper proposed a tunable band pass filter. It is two-poles direct capacitive coupled resonator band pass filter which the capacitors of parallel resonators are changed by varactor diodes. The DC bias controls to change the value of capacitance in the parallel resonator for tunning the pass band. To validate the proposed design method, we fabricated the band pass filter which has tunable center frequency from 200MHz to 245MHz.