http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
권영철,Gwon, Yeong-Cheol 대한양계협회 2019 월간 양계 Vol.51 No.8
본고는 금년 4월 26일 고려대학교에서 개최된 (사)대한건축학회 춘계학술발표대회에서 한라대학교 권영철 교수가 발표한 '한국의 계절별 계사의 부하 특성에 관한 연구' 내용을 발췌하여 게재하였다. 본 연구는 매년 여름 폭염으로 인한 닭들의 폐사를 줄이고 최적 단열 및 환기 방안을 마려하기 위한 연구의 일환으로 이루어졌다.
Existence of Periodic Solutions for Fuzzy Differential Equations
권영철,김정순,황진수,박진한 한국지능시스템학회 2010 INTERNATIONAL JOURNAL of FUZZY LOGIC and INTELLIGE Vol.10 No.3
In thispaper,weinvestigatetheexistenceandcalculationoftheexpressionofperiodicsolutionsforfuzzydifferential equations withthreetypesofforcingterms,byusingHukuharaderivative.Inparticular,Theorems3.2,4.2and5.2are the resultsofexistencesofperiodicsolutionsforfuzzydifferentialequations ,aandb, respectively.Theseresultswill help ustostudyphenomenawithperiodicpeculiaritysuchaswaveorsound
權泳徹,金是璟 진주산업대학교 1977 論文集 Vol.15 No.-
間伐이 편백나무의 直徑成長에 미치는 影響을 究明하기 위해서 南海郡 二東面 所在 25㏊의 편백나무 林分中 北向林分(A)에서 間伐區(A_1)와 無間伐區(A_2)를, 또한 西向林分(B)에서 間伐區(B_1)와 無間伐區(B_2)를 각각 0.1㏊씩의 標準地를 選定하고, 이 標準地의 林木을 生長錐를 使用해서 胸高部位의 南北 두 方向에서 Core를 採取하였다. 이 Core의 各 年輪폭을 測定하여 直徑成長의 實態를 考察한 바 이를 要約하면 다음과 같다. (1) 北向林分의 間伐區는 無間伐區에 比해서, 또한 西向林分의 間伐區는 無間伐區에 比해서 매우 넓은 年輪폭을 形成하였으며 한 年輪폭의 平均斷面積과 年輪폭의 累加面積은 2倍 以上의 成長을 하여 間伐의 效果를 뚜렷하게 나타내었다. (2) 西向林分의 間伐區 및 無間伐구는 北向林分의 間伐구 및 無間伐區에 比해서 다소 좋은 성장을 나타내고 있으며 이는 立木度, 方位, 傾斜度, 土深, 標高 등 立地條件의 差異로서 이루어진 것이 아닌가 생각된다. This study was carried out to determine the effect of thinning on the diameter growth of hinoki-cypress (Chamaecyparis obtusa Endl.) Each hinoki-cypress stand was seleced from the 25 ㏊. stand located at Leedong-Myeun Namhae-Goon. Each 0.1 ㏊. stand was designed by the thinning plot (A1) and the non thinning plot (A2) on the northern stand (A), and the thinning plot (B1) and non thinning plot (B2) on the western stand (B). This sample plot of the standing trees were taken the core of the breast hight (1.2m. above the ground) by using the increment borer on both the southern and northern directions. The results obtained were as follows : 1. On both western stand and northern stand, the annual ring width in thinned trees was wider than that in the unthinned. Each average cross section area and the annual ring area summed in thinned trees were more than twice larger than those in the unthinned. There was a significant effect of the thinning on diameter growth. 2. Growth rate of both thinned plot and the unthinned plot of the western stand was better than that of both thinned plot and unthinned plot on the northern stand respectively. It was assumed that this tendency would be caused by the differences of soil site conditions such as density of trees, bearing, degree of slope, soil depth, and altitude etc.
권영철 한국기계기술학회 2022 한국기계기술학회지 Vol.24 No.5
In the present study, the experimental study was conducted using a multi-calorie meter, to investigate the cooling performance and cycle operation changes of the multi-heat pump (3 indoor units) for the low outside temperature in summer. The test temperature condition was the low cooling temperature, and the normal performance and dynamic behavior of 3 rooms, 2 rooms, and 1 room were measured to understand the operating characteristics of seven 7 indoor unit combinations. As a result of the experiment, the cooling capacity and COP of the multi-heat pump at low cooling temperature were about 10% and 6% higher than those of the cooling standard temperature. In addition, the dynamic behavior of the indoor units of 3 and 2 rooms was observed differently due to the load difference according to the indoor unit combinations and the non-uniformity of the refrigerant amount. And, when starting the heat pump, the compressor had a maximum peak value and stabilized by repeating the decrease and increase for each indoor unit combination.
난방표준 온도조건에서 멀티 히트펌프의 운전특성에 대한 실험연구
권영철 한국기계기술학회 2022 한국기계기술학회지 Vol.24 No.4
In the present study, it is conducted to understand the heating performance and compressor operation characteristics according to 7 indoor unit combinations and 3 setting temperatures of the inverter multi-heat pump under heating standard temperature conditions. Heating capacity, COP and compressor frequency are investigated using the multi-calorimeter. The indoor unit combinations are simultaneous operation(A+B+C), partial operation(A+C, A+B, B+C) and independent operation(A, B, C), and the setting temperature is 20, 21, and 30°C. Since the increase in the setting temperature increases the compress frequency, the heating capacity increases, but COP decreases due to the increase in power consumption. The frequency increases as the indoor unit combination capacity increases, and decreases as the setting temperature decreases in the steady state.
슬릿과 평판 핀-관 열교환기의 공기측 열전달 및 마찰특성
권영철,장근선,박병권,권정태,정지환 한국에너지학회 2007 에너지공학 Vol.16 No.1
본 연구는 핀-관 열교환기의 건표면과 습표면 조건에서의 공기측 열전달 및 마찰특성을 실험을 통해 이해하고자 수행하였다. 핀-관 열교환기의 성능평가 및 해석기술을 확보하기 위하여 공기엔탈피식 칼로리미터를 이용하였다. 핀형상은 슬릿과 평판이며, 관경은 7.0 mm로 2열과 3열 핀-관 열교환기 4종에 대해 실험하여, 건표면과 습표면의 공기측 열전달 및 마찰특성을 조사하였다. 습표면에서 습도변화(RH 50%, 70%)에 따른 습도영향도 조사하였다. 건표면 조건에서 Re 수가 증가할수록 j 계수는 감소하며, 2열이 3열보다 높았다. 마찰계수는 슬릿 핀이 평판 핀보다 높았다. 습표면 조건에서 슬릿 핀이 평판 핀보다 그리고 2열이 3열보다 우수한 열전달효과를 나타내었다. j 계수와 마찰계수는 습도변화, 열수, 핀 형상에 따라 달라짐을 확인하였다.