Outgas 분석을 통한 MLCC Bar 변형률 측정 = Experimental Study on the Deformation of MLCC Compressed Bar by Quantitative Analysis for Outgas

다국어 초록 (Multilingual Abstract)

MLCC (multi-layer ceramic capacitor) is usually fabricated by lamination of predetermined number of single layers. Often, the state of MLCC before sintering is called the green state, whose strength comes from the adhesion between the dielectric material and the polymer binder. Therefore the lamination of a single layer before sintering can be easily deformed by environment due to the relatively lower strength. After the compression process, which helps single sheets cohereto with adjacent sheets, the MLCC green bar is preheated to resolve the probable internal stress. Unfortunately, unexpected deformation after preheating resulted in problems during cutting of the MLCC green bar. In this study, one of 2 primary hypotheses which were proposed to resolve the unexpected deformation after preheating was examined by quantitative experiment with GC/MS (gas chromatograpy/mass spectrometer). The proportion of deformation caused by DOP evaporation, which was primarily evaporated componet during preheating, to the total deformation of the MLCC green bar was found to be 53%.

참고문헌 (Reference)

1 S.-G. Lee, 4 : 169-, 1991

2 A. L. Chuck, 297 : 1151-, 2002

3 O. Chun, 20 : 53-, 1994

4 M. Tsige, 17 : S4119-, 2005

5 R. E. Mistler, "Tape Casting: Theory and Practice" The American Ceramic Society 152-, 2000

6 N. G. Mccrum, "Principles of polymer engineering" Oxford University Press 1997

7 S. H. Lee, "Minitab, Analysis of Measurement System" Eretec 25-, 2006

8 W. Callister, "Materials Science and Engineering" Wiley 430-, 1994

9 I. G. Currie, "Fundamental Mechanics of Fluids" McGraw-Hill Inc 1993

10 "Ceramic Processing before Firing" Wiley-Interscience Publication 1978

11 O. H. No, "Basics of Viscous Fluid Mecahnics" Pakyoungsa 33-, 1996

12 S. Middleman, "An Introduction to Mass and Heat Transfer" Wiley 3-, 1998