Numerical study on heat transfer and pressure drop in laminar-flow multistage mini-channel heat sink

다국어 초록 (Multilingual Abstract)

<P><B>Abstract</B></P> <P>Mini-channel has been more studied recently than micro-channel to optimize the heat emission and pressure drop by regulating the channel size and length. In this work, a multistage mini-channel heat sink using water coolant was designed to obtain a larger cooling rate in a small area with a lower pressure drop. To confirm the performance of the structure, we conducted numerical simulations under laminar and single-phase conditions. The diameter and length of the channel were 2 and 530mm, respectively. From the simulation, the local convection coefficient, coolant temperature, channel-wall temperature, effectiveness, and pressure drop were analyzed in relation to the mass flux, heat-source temperature, and number of stage stacks. To obtain valid simulation results on the heat transfer, we used well-matched conventional correlation. The result of the pressure drop was compared with the experimental result to confirm the validity of the hydrodynamic model. The simulation result shows that the maximum cooling rate was 40W/cm<SUP>2</SUP> at a pressure drop of 1383Pa in a quintuple-stage model. However, the triple-stage structure had the best effectiveness of 0.83 under the same simulation conditions. The pressure drop of the multistage structure was higher than that of the single-stage structure. However, the increase of the total pressure drop was small as against the increase of the cooling rate.</P> <P><B>Highlights</B></P> <P> <UL> <LI> A multistage mini-channel heat sink is proposed to increase the cooling rate. </LI> <LI> Numerical simulations were done to verify the multistage mini-channel performance. </LI> <LI> The optimum structure is the triple stage that yields the largest heat emission among the multistage mini-channel. </LI> <LI> Multistage structure could improve the cooling rate with the small increase of the pressure drop. </LI> </UL> </P>