The effect of injector configuration including the injection angle and number of nozzle holes has been investigated in a heavy duty diesel homogeneous charge compression ignition (HCCI) engine. The HCCI engine has advantages of simultaneous reduction ...
The effect of injector configuration including the injection angle and number of nozzle holes has been investigated in a heavy duty diesel homogeneous charge compression ignition (HCCI) engine. The HCCI engine has advantages of simultaneous reduction of PM (particulate matter) and NOx (nitrogen oxide) emissions by achieving the spatially homogeneous distribution of diesel and air mixture, which results in no fuel-rich zones and low combustion temperature. However, a fuel wall-film, which was formed on the surface of the piston squish area and cylinder liner, caused increases in HC (hydro carbon) and CO (carbon monoxide) emission. Also reduction of indicated mean effective pressure (IMEP) and deterioration of coefficient of variation-IMEP (COV-IMEP) was occurred because of excessively advanced ignition and the formation of lean air-fuel mixture.
A hole-type injector (8 holes) with small injection angle (70˚) instead of conventional angle (146˚) was applied to solve this problem. The multi-hole injector (14 holes) was also tested to maximize the atomization of diesel. Results showed that the small injection angle minimizes the wall-impingement of diesel fuel, and which result in high power output and low PM emission. The multi-hole injector could decrease the spray penetration at low in-cylinder pressure as well as improved fuel atomization. EGR (exhaust gas recirculation) was applied to compensate reduction of IMEP through retarding ignition timing after TDC (Top dead center). An increase in the amount of EGR resulted in further reduction in NOx and improvement of IMEP.