RISS 학술연구정보서비스

검색
다국어 입력

http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.

변환된 중국어를 복사하여 사용하시면 됩니다.

예시)
  • 中文 을 입력하시려면 zhongwen을 입력하시고 space를누르시면됩니다.
  • 北京 을 입력하시려면 beijing을 입력하시고 space를 누르시면 됩니다.
닫기
    인기검색어 순위 펼치기

    RISS 인기검색어

      검색결과 좁혀 보기

      선택해제
      • 좁혀본 항목 보기순서

        • 원문유무
        • 원문제공처
        • 등재정보
        • 학술지명
        • 주제분류
        • 발행연도
        • 작성언어
        • 저자
          펼치기
      • 무료
      • 기관 내 무료
      • 유료
      • KCI등재

        습윤/건조 반복 작용이 고흡수율 폴리머를 함유한 시멘트계 재료의 자기치유에 미치는 영향

        홍근태(Geuntae Hong),최성철(Seongcheol Choi) 한국건설순환자원학회 2020 한국건설순환자원학회 논문집 Vol.8 No.1

        이 연구에서는 고흡수율 폴리머(SAPs)를 포함하는 시멘트계 재료의 자기치유에 대한 습윤/건조 반복 작용의 영향을 실험적으로 평가하였다. 매 주기마다 SAP 함량을 변수로 하는 시멘트 페이스트 시편을 균열 이후 1시간 동안 습윤 조건에 노출시키고(흡수율시험 및 투수시험 진행), 47시간 동안 건조 조건에 노출시켰다. 흡수율시험 결과 SAP 미혼입 시편, SAP 0.5%, SAP 1.0%, SAP 1.5% 혼입 시편의 균열을 통한 흡수율이 각각 1주기 대비 8주기 이후 22.9%, 36.8%, 42.8%, 46.3% 감소한 것으로 나타났다. 또한, 투수시험 결과 모든 시편의 균열을 통한 물 유출량은 습윤/건조 주기에 따라 점차 감소하였으며, 특히 SAP 함량이 증가할수록 유량 감소율은 증가하였다. 또한, X-ray CT 분석을 통해 균열 내 SAPs의 유입수에 의한 팽윤 거동이 확인되었다. 실험 결과는 SAPs가 유입수를 흡수하여 팽윤함에 따라 유효 균열폭이 감소될 수 있고, SAPs는 흡수한 물을 건조 조건에서 주변 균열부에 공급함에 따라 치유 생성물의 형성을 촉진시킬 수 있음을 나타낸다. 이 연구의 결과는 SAPs의 혼입이 균열의 수밀성을 증가시킴에 따라 시멘트계 재료의 자기치유 성능을 향상시킬 수 있음을 나타낸다. In this study, the effect of cyclic wetting-drying on the self-healing of cementitious materials containing superabsorbent polymers (SAPs) were experimentally evaluated. In each cycle, cracked cement paste specimens containing various SAP dosages were exposed to wet conditions for 1 h, during which the capillary water absorption tests and water flow tests were conducted, and then exposed to dry conditions for 47 h. The capillary water absorption test results showed that the sorptivity values of the specimen without SAPs, SAP 0.5%, SAP 1.0%, and SAP 1.5% specimens were decreased by approximately 22.9%, 36.8%, 42.8%, and 46.3%, respectively, after 8 cycles. In addition, the water flow test results showed that the amount of water runoff through the cracks of all cracked specimens gradually decreased over wet/dry cycles, especially the reduction ratio of the amount of water runoff increased with increasing SAP dosage. Furthermore, the swelling behavior of SAPs in cracks by ingress water was confirmed via X -ray computed tomography (CT) analysis. These results indicate that the effective crack width can be reduced as SAPs absorb water and swell, while the water absorbed in SAPs can be released to crack surfaces under dry conditions, further promoting healing product formation. This study demonstrates that the in corporation of SAPs c an increase the water tightness of cracks, thereby improving the self-healing efficiency of cementitious materials.

      • KCI등재

        플라이애시 수중불분리성 콘크리트의 수밀성에 관한 실험적 연구

        권중현(JUNG-HYUN KWON),김봉익(BONG-IK KIM) 한국해양공학회 2008 韓國海洋工學會誌 Vol.22 No.4

        This paper describes the effects of fly ash replacement on the water tightness of antiwashout underwater concrete, which replaced the cement with fly ash from 0% to 30%. The experimental work was performed to find out the depth of permeation of concrete specimens cast in air and cured in 23℃ tap water using an open center pressure type of water permeation tester. The results showed that the permeation depth values of antiwashout underwater concrete were deeper than normal concrete, but that an admixture using fly ash during antiwashout underwater concrete casting in air made it more watertight than normal concrete according to the water permeation testing. SEM observations of the specimensof fly ash antiwashout underwater concrete showed that it wasmore packed with structures because of the pozzolan reaction of the fly ash and cement.

      • KCI등재

        조립용 콘크리트맨홀의 개발에 관한 연구

        한상호 ( Sang-ho Han ),남세풍 ( Se-poong Nam ) 한국환경기술학회 2005 한국환경기술학회지 Vol.6 No.1

        국내에서 사용되고 있는 대부분의 콘크리트맨홀은 일체형으로 되어 있으며, 이와 같은 일체형 콘크리트맨홀은 현장여건에 따라 맨홀의 크기와 입수 및 배수홀의 높이가 다르기 때문에 주문제작 또는 현장제작에 의존하고 있다. 그러나, 이와 같이 제작된 콘크리트맨홀은 공사기간의 지연을 초래하며, 입수 및 배수홀 주변에서 누수가 발생한다. 본 연구에서는 위와 같은 문제점을 해결하기 위하여 기존의 일체형 콘크리트맨홀을 분할 제작하고, 이들을 현장 여건에 적합하도록 조립하여 사용할 수 있는 조립용 콘크리트맨홀 제품을 개발하였다. Most of concrete manholes using in the country are single body. And these are making in the field or making by order according to the field conditions which is different manhole`s size, and height of in or out hall. But, concrete manholes made by those ways cause delay of construction period and water leakage around in or out hall. To solve the problems, in this study, a single body concrete manhole manufactured in pieces, and prefabricated concrete manhole that can use to assemble in the field has developed.

      연관 검색어 추천

      이 검색어로 많이 본 자료

      활용도 높은 자료

      해외이동버튼