http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Mu Liu,Yongzhen Peng,Qing Yang,Tiantian Liu, Han Xiao,Shuying Wang 한국공업화학회 2015 Journal of Industrial and Engineering Chemistry Vol.32 No.-
Landfill leachate was treated using the upflow anaerobic sludge blanket (UASB) combined with anoxic/aerobic reactor (A/O) for shortcut biological nitrogen removal. The treatment performance and nitrousoxide (N2O) emission were studied under different salinity. When salinity increased from 10 to 35 g/L,the removal efficiency of ammonium nitrogen and total nitrogen decreased from 99.3 to 83.9% and from85.4 to 68.4%, respectively while the nitrite accumulation rate always remained high at more than 94.3%. The N2O conversion ratio increased by 14.7 times, from 0.3 to 4.7%. The concentration of biodegradableCOD in influent of the A/O reactor increased with the increase of salinity, which lead to the decrease ofdissolved oxygen and thus stimulated N2O emission remarkably during the aerobic zone. Meanwhile, theN2O emissions were likely to occur by a combination of pathways since the simultaneous nitritation anddenitritation was occurred in aerobic zone. The increase of NH4+-N concentration, NO2-N concentrationand pH caused by high salinity also promoted the N2O emission. The population of Nitrosomonaseuropaea increased with salinity, which was important for N2O emission.
SOOT DEVELOPMENT IN AN OPTICAL DIRECT INJECTION SPARK IGNITION ENGINE FUELED WITH ISOOCTANE
Fangxi Xie,Miaomiao Zhang,Yongzhen Wang,Yan Su,Wei Hong,Peng Cheng 한국자동차공학회 2021 International journal of automotive technology Vol.22 No.2
To better understand the formation and evolution processes of soot, the two-color laser induced incandescence diagnostic method was applied on a single cylinder optical direct injection spark ignition engine. Soot volume fraction was measured, and soot distribution was imaged as cyclic fuel quantity changes. The results show that 45.5 mg/cycle generates the most soot at the same measure plane. Pool fire dominates the formation of soot in the tested engine and generates more soot on the top surface of the piston near the injector. In-cylinder soot increases until 42°CA ATDC and then reduces due to oxidation. Pool fire continues through the expansion stroke till 52°CA ATDC, and then soot cloud gathers near the 10 mm plane. After 82°CA ATDC, in-cylinder soot basically in equilibrium, and residual soot moves follow the in-cylinder flow randomly and evenly distributes within the whole combustion chamber. With increasing cyclic fuel quantity, particles number concentration gradually increases and their distribution present dual-peak shape. In detail, 45.5 mg/cycle emits the most accumulation mode particles while 52 mg/cycle emits the most nucleation mode particles.
Mechanical simulation for the bending process of the AMOLED panel pad
Wu Di,Jia Yongzhen,Liao Dunming,Zhang Bo,Liu Chen,Wang Ning,Peng Wenjing,Huang Liting 한국정보디스플레이학회 2023 Journal of information display Vol.24 No.2
Panel pad bending is a critical process to improve the screen-to-body ratio of an active-matrix organic light-emitting diode (AMOLED) panel. The failure analysis of the metal wirings is the key to ensure the reliability of signal transmission when the pad be bent to the back of the panel. In the present work, the sub-modeling technique combined with the periodic boundary condition was used to simulate the stress distribution of the bending area of the pad. The progressive failure of bent metal wirings was investigated by the extended finite element method. It is proved to be rational to prevent the wirings damage if the interlayer dielectric is replaced by an organic layer. In order to reduce stress of metal wirings, it is a measure to replace the original ultraviolet (UV) curable adhesive with a higher-modulus UV adhesive. The simulated results also show that rectangular perforations can avoid the stress concentration caused by the holes compared with circular perforations. For better stress distribution of metal wirings, it is necessary to increase the lengths of the rectangular holes and decrease the widths of that to a certain extent, which is helpful for restraining crack propagation by means of low-stress zones and holes.
Molecular Cloning and Characterization of a Novel Stem-specific Gene from Camptotheca acuminata
Pi, Yan,Liao, Zhihua,Chai, Yourong,Zeng, Hainian,Wang, Peng,Gong, Yifu,Pang, Yongzhen,Sun, Xiaofen,Tang, Kexuan Korean Society for Biochemistry and Molecular Biol 2006 Journal of biochemistry and molecular biology Vol.39 No.1
In higher plants, P450s participate in the biosynthesis of many important secondary metabolites. Here we reported for the first time the isolation of a new cytochrome P450 cDNA that expressed in a stem-specific manner from Camptotheca acuminata (designated as CaSS), a native medicinal plant species in China, using RACE-PCR. The full-length cDNA of CaSS was 1735 bp long containing a 1530 bp open reading frame (ORF) encoding a polypeptide of 509 amino acids. Bioinformatic analysis revealed that CASS contained a heme-binding domain PFGXGRRXCX and showed homology to other plant cytochrome P450 monooxygenases and hydroxylases. Southern blotting analysis revealed that there was only one copy of the CaSS present in the genome of Camptotheca acuminata. Northern blotting analysis revealed that CaSS expressed, in a tissue-specific manner, highly in stem and lowly in root, leaf and flower. Our study suggests that CaSS is likely to be involved in the phenylpropanoid pathway.