http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Mohsen Ghahremanian,Behzad Niroumand,Masoud Panjepour 대한금속·재료학회 2012 METALS AND MATERIALS International Vol.18 No.1
Al-7wt%Si-10wt%SiCp composite with uniformly distributed reinforcement particles with the average size of about 3 microns was produced by a special compocasting method in which the reinforcement was injected into the melt in the form of particulate Al-SiCp composite powder instead of SiCp. The effects of the rein-forcement addition form, the solid fraction of primary alpha-aluminum particles at pouring, and stirring speed on the incorporation of reinforcement particles into the matrix were investigated. Injection of particulate Al-SiCp composite led to improved incorporation and dispersion and reduced size of SiCp. Casting from the semisolid state significantly improved the incorporation of SiCp into the matrix. The optimal solid fraction of primary alpha-aluminum particles to achieve a reasonable combination of reinforcement incorporation and fluidity of the composite slurry was recognized to be about 0.1. The incorporation of SiCp was improved by increasing the stirring speed up to 500 rpm and then gradually decreased.
Elahi Davaji Hossein,Shamoradi Fatemeh,Panjepour Masoud,Ahmadian Mehdi 한국탄소학회 2022 Carbon Letters Vol.32 No.1
The current study was intended to synthesize and characterize the physical, chemical, and mechanical properties of carbon/carbon (C/C) composites using the chemical vapor infiltration (CVI) process. To that end, carbon fiber felt (CF) was used as a preform, and methane and hydrogen were employed as reactive and carrier gases, respectively. After deciding on the optimum temperature (1050 °C), the composite samples were produced at different times (0–195 h). Then the samples were studied for their phase and microstructure characteristics using XRD, SEM, FESEM, FTIR, and Raman spectroscope. The results showed that by increasing the CVI process time up to 195 h, the density of the produced samples increased from 0.20 to 1.62 g/cm3, and the specific surface area decreased from 58.78 to 0.23 m2/g. Also, by increasing the process duration, the deposition rate decreased due to the reduction of the available surface for carbon deposition. In other words, due to the increase in density, and decrease in both porosity and specific surface area, the thermal conductivity coefficient and the bending strength of the samples increased. The composite specimens' SEM images of the fracture surface indicated a weak interface between the carbon fibers and the carbon layer developed by the CVI process. The structural analyses showed that the morphology of carbon growth during the CVI process was initially laminar, but changed to rough-laminar (RL) with the higher duration of the CVI process.