http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Joshi, Anil,Mathur, A.K.,Naqvi, S.M.K.,Mittal, J.P. Asian Australasian Association of Animal Productio 2006 Animal Bioscience Vol.19 No.12
The present study was conducted to observe the effect of osmolality of glycerolated TEST-yolk glycerol extenders on post-thawing sperm kinematics of ram spermatozoa of the native Malpura breed maintained in a semi-arid tropical environment. Good quality semen obtained from adult rams was pooled, split and diluted to 1,000 million spermatozoa per ml in complete TEST-yolk-glycerol extenders of 900, 1,200, 1,500 and 1,800 mOsm/kg osmolality. Diluted semen samples were loaded in 0.25 ml straws and cooled down to $-125^{\circ}C$ freezing temperature at the rate of $-25^{\circ}C$ per minute under controlled conditions before plunging into liquid nitrogen for storage. The thawing of straws was performed at $50^{\circ}C$ in a water bath for 10 seconds and sperm kinematics of the frozen-thawed spermatozoa were assessed by a computer-assisted sperm analysis technique. Osmolality of diluent had no significant effect on post-thawing % motility, % rapid, % medium and % slow moving frozen-thawed spermatozoa but significantly (p< 0.05) affected the % linearity and % straightness. The post-thawing % motility and % rapid motile spermatozoa were highest in samples extended in diluent of 1,500 mOsm/kg osmolality and lowest in 900 mOsm/kg. The curvilinear velocity of spermatozoa was significantly (p<0.05) higher for samples extended in 1,800 mOsm/kg, compared to those in 900 and 1,200 mOsm/kg, but the effect was not significantly different to those extended in diluent of 1,500 mOsm/kg osmolality. The study indicated that ram spermatozoa could tolerate a wide osmolality range for dilution in the complete TEST-yolk-glycerol extender for their cryosurvival. The highest recovery of motile spermatozoa following thawing was achieved in samples extended in the TEST-yolk-glycerol diluent of 1,500 mOsm/kg osmolality.
Wrapper Based Wavelet Feature Optimization for EEG Signals
Girisha Garg,A.P. Mittal,Vijander Singh,J.R.P Gupta 대한의용생체공학회 2012 Biomedical Engineering Letters (BMEL) Vol.2 No.1
Purpose In this paper a computationally efficient wrapper based Wavelet Feature Optimization (WFO) is developed. The algorithm is developed for the classification of high dimensional EEG signals which may suffer from the curse of dimensionality and sub optimal feature selection. Methods The key design phases of the algorithm involve: 1)Feature Transformation of the original EEG signals using Discrete Wavelet Transform; 2) Feature Extraction using the concept of Relative Wavelet Energy (RWE) 3) Selecting the optimal subset of the RWE features using wrapper approach. In contrast to the methods guided by the filter technique of feature selection, this approach uses the wrapper based method to select the optimal and a very low dimensional feature space from the wavelet features. Results The highlight of the algorithm is that in addition to increase the computational efficiency, it also enhances the predictive power of the system without any loss of relevant information. This paper includes the experimentation performed on EEG datasets using WFO algorithm. Conclusions The algorithm gives consistent and excellent performance for the EEG datasets. The feature sets obtained with the help of WFO are also tested using mutual information methods to confirm the optimality of the wavelet feature subset.
Effect of Thermal Stress on Sexual Behaviour of Superovulated Bharat Merino Ewes
Maurya, V.P.,Naqvi, S.M.K.,Gulyani, R.,Joshi, A.,Mittal, J.P. Asian Australasian Association of Animal Productio 2005 Animal Bioscience Vol.18 No.10
The present study was undertaken to study the effect of thermal stress on sexual behaviour of superovulated ewes. Fourteen adult Bharat Merino ewes with an average body weight of 29.4${\pm}$2.34 kg were randomly allocated into two groups of 7 each. All the animals were grazed on natural pasture in the morning and evening hours and housed in shed during night. Animals of Group-1 were housed in shed from 10:00 to 16:00 h while the animals of Group-2 were exposed to thermal stress in a hot chamber ($40^{\circ}C$ /6 h/day). All the animals were offered drinking water once a day at 16:30 h. Meteorological observations i.e. dry bulb, wet bulb, minimum and maximum temperature were recorded daily inside the shed as well as in hot chamber throughout the experimental period. For superovulation of animals, standard protocol developed at the Institute, using FSH (Ovagen 5.4 mg in eight injections) and PMSG (200 IU) was followed. Various sexual behaviour parameters (circling, tail fanning, head turning, standing and approaching to ram) and estrus incidence (onset of estrus and estrus duration) were observed in both the groups. The different estrus symptoms were graded subjectively on arbitrary scale of 0-5 where 0 representing no sexual behaviour (0%) and 5 representing maximum intensity in sexual behaviour (100%). Estrus was detected with the help of a marked aproned ram of proven vigor at six hourly intervals. The average percent values for sexual behaviour parameters recorded in Group-1 and Group-2 animals were 53.7${\pm}$3.76 vs. 41.1${\pm}$2.18 for circling, 71.8${\pm}$5.42 vs. 49.0${\pm}$4.41 for tail fanning, 64.7${\pm}$3.30 vs. 44.5${\pm}$4.34 for head turning, 90.1${\pm}$3.16 vs. 75.8${\pm}$4.02 for standing and 63.8${\pm}$4.8 vs. 41.9${\pm}$4.58 for approaching to ram. Animals exposed to thermal stress had significantly lower values of these sexual behaviour parameters. The animals kept in shed exhibited estrus earlier (25.4${\pm}$1.12 h) and duration was higher (37.7${\pm}$1.59 h) as compared to animals exposed to thermal stress i.e. 30.6${\pm}$1.16 h and 31.7${\pm}$3.57 h, respectively. The findings of the study indicate that thermal stress reduces the intensity of sexual behaviour in ewes and may result in failure of the animal to mate and conceive.
Prerna Gaur,Bhim Singh,A.P. Mittal 전력전자학회 2008 JOURNAL OF POWER ELECTRONICS Vol.8 No.3
This paper deals with an investigation and evaluation of the performance of a state observer based Permanent Magnet Synchronous Motor (PMSM) drive controlled by PI (Proportional Integral), PID (Proportional Integral and Derivative), SMC (sliding mode control), ANN (Artificial neural network) and FLC (Fuzzy logic) speed controllers. A detailed study of the steady state and dynamic performance of estimated speed and angle is given to demonstrate the capability of the controllers.
Gaur, Prerna,Singh, Bhim,Mittal, A.P. The Korean Institute of Power Electronics 2008 JOURNAL OF POWER ELECTRONICS Vol.8 No.3
This paper deals with an investigation and evaluation of the performance of a state observer based Permanent Magnet Synchronous Motor (PMSM) drive controlled by PI (Proportional Integral), PID (Proportional Integral and Derivative), SMC (sliding mode control), ANN (Artificial neural network) and FLC (Fuzzy logic) speed controllers. A detailed study of the steady state and dynamic performance of estimated speed and angle is given to demonstrate the capability of the controllers.
Torque Ripples Minimization of DTC IPMSM Drive for the EV Propulsion System using a Neural Network
Singh, Bhim,Jain, Pradeep,Mittal, A.P.,Gupta, J.R.P. The Korean Institute of Power Electronics 2008 JOURNAL OF POWER ELECTRONICS Vol.8 No.1
This paper deals with a Direct Torque Control (DTC) of an Interior Permanent Magnet Synchronous Motor (IPMSM) for the Electric Vehicle (EV) propulsion system using a Neural Network (NN). The Conventional DTC with optimized switching lookup table and three level torque controller generates relatively large torque ripples in an electric vehicle motor drive. For reducing the torque ripples, a three level torque controller is hereby replaced by the five level torque controller. Furthermore, the switching lookup table of the five level torque controller based DTC is replaced with a Neural Network. These DTC schemes of an IPMSM drive are simulated using MATLAB/SIMULINK. The simulated results are compared with the conventional DTC and it is found that the ripples in the torque, as well as in the stator current, are reduced drastically.
Torque Ripples Minimization of DTC IPMSM Drive for the EV Propulsion System using a Neural Network
Bhim Singh,Pradeep Jain,A.P.Mittal,J.R.P.Gupta 전력전자학회 2008 JOURNAL OF POWER ELECTRONICS Vol.8 No.1
This paper deals with a Direct Torque Control (DTC) of an Interior Permanent Magnet Synchronous Motor (IPMSM) for the Electric Vehicle (EV) propulsion system using a Neural Network (NN). The Conventional DTC with optimized switching lookup table and three level torque controller generates relatively large torque ripples in an electric vehicle motor drive. For reducing the torque ripples, a three level torque controller is hereby replaced by the five level torque controller. Furthermore, the switching lookup table of the five level torque controller based DTC is replaced with a Neural Network. These DTC schemes of an IPMSM drive are simulated using MATLAB/SIMULINK. The simulated results are compared with the conventional DTC and it is found that the ripples in the torque, as well as in the stator current, are reduced drastically.
Optimal Speed Control of Hybrid Electric Vehicles
Yadav, Anil Kumar,Gaur, Prerna,Jha, Shyama Kant,Gupta, J.R.P.,Mittal, A.P. The Korean Institute of Power Electronics 2011 JOURNAL OF POWER ELECTRONICS Vol.11 No.4
The main objective of this paper is to control the speed of Nonlinear Hybrid Electric Vehicle (HEV) by controlling the throttle position. Various control techniques such as well known Proportional-Integral-Derivative (PID) controller in conjunction with state feedback controller (SFC) such as Pole Placement Technique (PPT), Observer Based Controller (OBC) and Linear Quadratic Regulator (LQR) Controller are designed. Some Intelligent control techniques e.g. fuzzy logic PD, Fuzzy logic PI along with Adaptive Controller such as Self Organizing Controller (SOC) is also designed. The design objective in this research paper is to provide smooth throttle movement, zero steady-state speed error, and to maintain a Selected Vehicle (SV) speed. A comparative study is carried out in order to identify the superiority of optimal control technique so as to get improved fuel economy, reduced pollution, improved driving safety and reduced manufacturing costs.
Optimal Speed Control of Hybrid Electric Vehicles
Anil Kumar Yadav,Prerna Gaur,Shyama Kant Jha,J. R. P. Gupta,A. P. Mittal 전력전자학회 2011 JOURNAL OF POWER ELECTRONICS Vol.11 No.4
The main objective of this paper is to control the speed of Nonlinear Hybrid Electric Vehicle (HEV) by controlling the throttle position. Various control techniques such as well known Proportional-Integral-Derivative (PID) controller in conjunction with state feedback controller (SFC) such as Pole Placement Technique (PPT), Observer Based Controller (OBC) and Linear Quadratic Regulator (LQR) Controller are designed. Some Intelligent control techniques e.g. fuzzy logic PD, Fuzzy logic PI along with Adaptive Controller such as Self Organizing Controller (SOC) is also designed. The design objective in this research paper is to provide smooth throttle movement, zero steady-state speed error, and to maintain a Selected Vehicle (SV) speed. A comparative study is carried out in order to identify the superiority of optimal control technique so as to get improved fuel economy, reduced pollution, improved driving safety and reduced manufacturing costs.