http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Yan, L.,Han, D.L.,Meng, Q.W.,Lee, J.H.,Park, C.J.,Kim, I.H. Asian Australasian Association of Animal Productio 2010 Animal Bioscience Vol.23 No.8
Forty-eight ((Duroc${\times}$Yorkshire)${\times}$Landrace) pigs with an average initial body weight (BW) of $48.47{\pm}1.13\;kg$ were used in a 12-week growth trial to investigate the influence of Anion (silicate) supplementation on growth performance, nutrient digestibility, meat quality and fecal noxious gas content in growing-finishing pigs. Pigs were allotted into three dietary treatments in a randomized complete block design according to sex and initial BW. Each dietary treatment consisted of four replications with four pigs per pen. Dietary treatments included: i) CON (basal diet), ii) HCI (basal diet+3 g/kg Anion), iii) HCII (basal diet+6 g/kg Anion). No significant difference (p>0.05) was detected for average daily gain (ADG), average daily feed intake (ADFI) and gain/feed ratio (G/F) throughout the experiment, although dietary supplementation of Anion numerically increased these characteristics compared with CON. The dietary HCI group significantly (p<0.05) increased the coefficient of total tract apparent digestibility (CTTAD) of dry matter (DM), nitrogen (N) and energy compared with the CON group (p<0.05). No significant difference was observed in meat quality except that meat firmness was linearly (p<0.05) increased by the Anion supplementation, while an increased tendency in meat color and a decreased tendency in 2-thiobarbituric acid reactive substances (TBARS) was also observed (p<0.10). Anion supplementation linearly (p<0.05) decreased the fecal $NH_3$ compared with the CON group. However, dietary Anion supplementation at 3 g/kg decreased the $H_2S$ concentration compared with CON, while no significant difference was detected in the HCII group, although the $H_2S$ emission was numerically decreased compared with CON. In conclusion, supplementation of the diet with 3 g/kg Anion was found to exert a beneficial effect on nutrient digestibility and meat quality of growing-finishing pigs, and concomitantly decreased the noxious gas emission without negative effect on growth performance.
Multi-pass laser welding of thick plate with filler wire by using a narrow gap joint configuration
Y. C. Yu,S. L. Yang,Y. Yin,C. M. Wang,X. Y. Hu,X. X. Meng,S. F. Yu 대한기계학회 2013 JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY Vol.27 No.7
A 17 mm low-carbon steel plate is welded by a fiber laser with a narrow gap joint configuration and multi-pass technique. A highspeed camera is used to real-time monitor the welding process, and the effects of groove size and the side shielding gas on the weld quality are studied. Experimental results showed that a concave shape in the bottom of weld can be formed when use a general shielding gas nozzle with the 8.0 mm external diameter. Through a special design of the shielding gas nozzle with the 2.0 mm external diameter which can deep into the interior of groove, the pressure from shielding gas can balance the surface tension from the liquid in the top of groove,so the shielding effect can be dramatically improved and the concave shape in the bottom of weld can be eliminated. When the filler wire and laser beam can smoothly enter the groove, using a relatively small groove size not only reduce the consumption of filler wire but also reduce the deflection of filler wire in the gap that can improve the fusion of groove.
γ-LA-Supplementation to IVC for IVP Bovine Embryos
Gaja, A.,Meng, C.L.,Sato, M.,Nakajima, T.,Kubota, Chikara,Kojima, T. Asian Australasian Association of Animal Productio 2010 Animal Bioscience Vol.23 No.1
The present study aimed to examine the effects of ${\gamma}$-linolenic acid (GLA) supplementation to in vitro culture (IVC) medium on in vitro developmental competence, freezability and morphology of in vitro matured and fertilized bovine embryos. In vitro produced (IVP) bovine zygotes were cultured in IVC medium supplemented with 0 (negative control), 15, 31, 62, 125, 250, 500 or 1,000 ppm GLA, 250 ppm linoleic acid albumin (LAA) and without any supplement as a control. Day 6 blastocysts derived from culture control were cultured in IVC medium containing either 62, 250 GLA or 250 LAA for 24 h, and at Day 7 were subjected to freezing or morphological examination by electron microscope. GLA 15 showed a tendency to have a higher cleavage rate at Day 2 (70.3%) than other groups. The hatching rate at Day 9 in LAA (38.2%) was significantly higher than the control and all treatment groups (p<0.05), while the blastocyst rate in LAA (32.4%) did not differ from those of 15 (30.5%), 31 (27.1%), and 62 GLA (33.1%) or the control (35.1%). GLA in concentrations of 125, 250, 500, and 1,000 ppm had significantly detrimental effect on the blastocyst rate compared to 15, 31 and 62 ppm GLA, LAA, and control groups (p<0.05). In contrast, the highest post-thaw survival rate (100%) was observed in the control group (p<0.01). Large lipid droplets were observed in the cytoplasm of trophoblastic cells, even in the control, but were abundant in GLA groups. Taking the results of the study into consideration, the addition of GLA to the culture medium for IVP bovine embryos at the dose of 15 ppm increased the developmental competence of zygotes and enhanced the cleavage rate up to Day 2. However, blastulation rate and post-thaw survival were not increased when GLA was added to the culture media.
Wu, Y.,Chen, Z.,Meng, Z.,Hu, L.,Gonzalez de Vicente, S.M.,Merrill, B.,Panayotov, D.,Zucchetti, M.,Kolbasov, B.,van Houtte, D.,Bustreo, C.,Kim, Y.,Sakamoto, Y.,Kim, K.,Maisonnier, D.,Clark, D.,Kalashni International Atomic Energy Agency 2018 Nuclear fusion Vol.58 No.9
<P>The 2nd International Workshop on Environmental, Safety and Economic Aspects of Fusion Power (ESEFP) was held on 23 September 2017 in Kyoto, Japan. The workshop was initiated by the International Energy Agency Technology Collaboration Program on ESEFP. The workshop was well attended with approximately forty participants representing fifteen institutions in eight countries. The presentations covered safety issues and environmental impacts, availability improvement and risk control and socio-economic aspects of fusion power. Quantitative safety assessment of fusion reactors was discussed in depth with the consensus output presented as a plenary presentation at the 13th International Symposium on Fusion Nuclear Technology (ISFNT-13). The next workshop is planned to be held in conjunction with the ISFNT-14 in 2019.</P>
Development of a novel self-centering buckling-restrained brace with BFRP composite tendons
Z. Zhou,X.T. He,J. Wu,C.L. Wang,S.P. Meng 국제구조공학회 2014 Steel and Composite Structures, An International J Vol.16 No.5
Buckling-restrained braces (BRBs) have excellent hysteretic behavior while buckling-restrained braced frames (BRBFs) are susceptible to residual lateral deformations. To address this drawback, a novel self-centering (SC) BRB with Basalt fiber reinforced polymer (BFRP) composite tendons is presented in this work. The configuration and mechanics of proposed BFRP-SC-BRBs are first discussed. Then an 1840-mm-long BFRP-SC-BRB specimen is fabricated and tested to verify its hysteric and self-centering performance. The tested specimen has an expected flag-shaped hysteresis character, showing a distinct self-centering tendency. During the test, the residual deformation of the specimen is only about 0.6 mm. The gap between anchorage plates and welding ends of bracing tubes performs as expected with the maximum opening value 6 mm when brace is in compression. The OpenSEES software is employed to conduct numerical analysis. Experiment results are used to validate the modeling methodology. Then the proposed numerical model is used to evaluate the influence of initial prestress, tendon diameter and core plate thickness on the performance of BFRP-SC-BRBs. Results show that both the increase of initial prestress and tendon diameters can obviously improve the self-centering effect of BFRP-SC-BRBs. With the increase of core plate thickness, the energy dissipation is improved while the residual deformation is generated when the core plate strength exceeds initial prestress force.
Long, Y,Shi, J,Qiu, D,Li, R,Zhang, C,Wang, J,Hou, J,Zhao, J,Shi, L,Park, Beom-Seok,Choi, S R,Lim, Y P,Meng, J Genetics Society of America [etc.] 2007 Genetics Vol.177 No.4
<P>Most agronomical traits exhibit quantitative variation, which is controlled by multiple genes and are environmentally dependent. To study the genetic variation of flowering time in Brassica napus, a DH population and its derived reconstructed F(2) population were planted in 11 field environments. The flowering time varied greatly with environments; 60% of the phenotypic variation was attributed to genetic effects. Five to 18 QTL at a statistically significant level (SL-QTL) were detected in each environment and, on average, two new SL-QTL were discovered with each added environment. Another type of QTL, micro-real QTL (MR-QTL), was detected repeatedly from at least 2 of the 11 environments; resulting in a total of 36 SL-QTL and 6 MR-QTL. Sixty-three interacting pairs of loci were found; 50% of them were involved in QTL. Hundreds of floral transition genes in Arabidopsis were aligned with the linkage map of B. napus by in silico mapping; 28% of them aligned with QTL regions and 9% were consistent with interacting loci. One locus, BnFLC10, in N10 and a QTL cluster in N16 were specific to spring- and winter-cropped environments respectively. The number of QTL, interacting loci, and aligned functional genes revealed a complex genetic network controlling flowering time in B. napus.</P>