http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
콘크리트의 고강도화에 관한 제안 ( A Proposal on High Strength Concrete Manufacture )
한천구 대한건축학회 1981 建築 Vol.25 No.4
본 고찰은 콘크리트를 고강도화하기 위한 방안으로서 재료에 관한 선정, 혼합 및 타설, 양성, 계획 등으로 분류하고, 이에 관한 이용 및 실무에 대한 검토를 하고자 한다.
한천구 대한건축학회 1983 建築 Vol.27 No.2
본연구는 섬유의 여러 종류중 가장 호율적이라고 알려진 강섬유 (Steel fiber)에 관한 예비실험으로서는 물.시멘트비, 재령, 사용량등 일반적인 섬유보강 콘크리트의 특성을 규명하도록 계획하였고, 본실험에서는 예비실험에 근거하어 섬유의 형태에 관한 제변수에 따라 인장강도에 미치는 영향을 중점적으로 분석하고자 하였다. 그리고 압축강도및 탄성계수에 관하여도 실험하여 비교 분석하였다.
한천구 대한건축학회 1984 建築 Vol.28 No.2
본 연구는 고갈골재자원 대책의 일환으로 천연강모래 강자갈과 쇄석 및 백토(일명 마사토)를 상호변화 조합시켜 백토및 쇄석을 사용한 콘크리트의 활용성을 구명하고 아울러 경제성도 분석하도록 실험계획 하였다.
Mock-Up 시험에 의한 고성능 콘크리트의 수축특성 분석
한천구,강수태,고경택,한창평 한국구조물진단유지관리공학회 2006 한국구조물진단유지관리공학회 논문집 Vol.10 No.5
본 연구는 개발된 저수축 고성능 콘크리트를 대상으로 모의부재 시험체에 있어서 콘크리트의 기초적 물성과 수축특성에 대하여 검토한 것이다. 실험연구 결과, 콘크리트의 배합특성으로 제안 배합은 목표 슬럼프플로우 및 목표 공기량을 만족하기 위해 SP제량 증가, AE제량 감소의 배합보정이 필요하였다. 응결시간은 제안 배합이 8시간 정도 빠르게 나타났으며, 굳은 콘크리트의 압축강도는 60MPa 이상의 고강도로 나타냈다. 수축특성으로 제안 배합 자기수축의 경우 플레인 배합 자기수축에 비해 50% 정도 저감되었고, 제안 배합의 중심부 건조수축은 수분발산이 없는 것에 기인하여 자기수축과 유사한 경향이었으나, 표면부는 크게 수축하였다. 단, 철근배근 시험체인 경우는 철근구속에 의해 내부 및 표면의 수축량이 작게 나타났다. This paper investigates the fundamental properties and shrinkage characteristics of low shrinkage high performance concrete(LSHPC), using mock-up specimens. According to the test results, the most suitable mix proportions of LSHPC need a higher dosage of SP agent and AE agent, in order to obtain the target of slump flow and air content. This is due to reduce fluidity and air content respectively. It also presented earlier setting time than control concrete by 6 hours and exhibited compressive strength of 60MPa at age 28 days. Autogenous shrinkage of LSHPC was the half of the value of control concrete. Drying shrinkage of center section of LSHPC showed similar tendency with autogenous shrinkage, because of no internal moisture movement, while surface section had larger drying shrinkage. The specimen with embedded reinforcing bar had smaller deformation owing to confinement of reinforcing bar.
이중버블시트의 포설 시공조건 변화에 따른 한중 콘크리트의 단열보온 성능 분석
한천구,한민철,백대현 한국건축시공학회 2010 한국건축시공학회지 Vol.10 No.5
The present research examined heat insulation performance according to change of various laid construction conditions of double bubble sheet being used as material for heat insulation & curing construction of cold weather concrete, and its results are as follows. First, the change in a laid period of bubble sheet within 4 hours and the change in water content inside bubble sheet overall showed similar temperature history and maturity without a big difference in terms of the temperature history of concrete according to construction factors, but it could be confirmed that when a structure was thin or several bubble sheets are laid, requisites unfavorable for initial curing of concrete can occur if a lagger distance between sheets is generated. In terms of the compressive strength of concrete core specimens, it appeared that the initial compressive strength is declined when conditions unfavorable for concrete curing such as delay of a laid period of bubble sheets, induction of large distance between sheets, increase of water content inside bubble sheets and thinness of a structure of placing concrete, etc. were applied, but it appeared that as its age passes, the difference becomes small. 본 연구에서는 한중 콘크리트의 단열보온양생 공법재료로 사용되고 있는 이중버블시트의 다양한 포설 시공조건 변화에 따른 단열보온성능을 검토하였는데, 그 결과는 다음과 같다. 먼저, 시공요인에 따른 콘크리트의 온도이력의 경우 4시간 이내의 버블시트 포설시기 변화 및 버블시트내 함수율 변화는 전체적으로 큰 차이없이 유사한 온도이력 및 적산온도를 나타냈으나, 구조체가 얇거나 여러 장의 버블시트를 포설할 경우 시트간 간격이 크게 발생하면 콘크리트 초기양생에 불리한 요건이 발생할 수 있음을 확인할 수 있었다. 콘크리트의 코어공시체 압축강도는 버블시트의 포설시기를 지연시키거나, 시트간 간격을 크게 유발시키거나, 버블시트내 함수율을 증가시키거나, 타설 콘크리트 구조체 두께가 얇게 되는 등 콘크리트 양생에 불리한 조건을 적용시킬수록 초기 압축강도는 저하하는 것으로 나타났으나, 재령이 경과할수록 그 차이는 작아지는 것으로 나타났다.