http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
2 상조직강의 항복 및 변형거동에 미치는 퍼얼라이트의 영향
최병영,오상엽 대한금속재료학회(대한금속학회) 1987 대한금속·재료학회지 Vol.25 No.9
The dual phase steels of ferrite-martensite and ferrite-martensite-pearlite were prepared by two step cooling or isothermal holding after intercritical annealing. And this research investigated the effect of pearlite on the yielding and deformation behavior of these dual phase steels. It was observed that second phase particles with pearlite-martesite interfaces were distributed in the ferrite matrix. The structure of pearlite-martensite interface was also observed by using SEM. Continuous or discontinuous yielding apeared in the specimens of ferrite-martensite-pearlite. The lower yielding ratio and continuous yielding were shown in the specimens with more martensite content (≥5.8 vol%). The microstructure observed by TEM showed that the mobile dislocations causing continuous yielding and the pinned dislocations by solute atoms were distributed in the ferrite. The effect of pearlite on the variation of work hardening exponents during tensile deformation was also discussed in terms of the Modified Crussard-Jaoul analysis.
3차원 지하수 유동과 반응성용질이동 모델을 활용한 우라늄 흡착 및 이동에 관한 개념 모델링
최병영,고용권,윤성택,김건영,Choi, Byoung-Young,Koh, Yong-Kwon,Yun, Seong-Taek,Kim, Geon-Young 대한자원환경지질학회 2008 자원환경지질 Vol.41 No.6
본 연구에서는 지구화학 모델을 활용하여 지하수 환경에서의 우라늄의 존재 형태, 흡착 및 이동 특성을 모사해 보았다. 흡착에 의한 우라늄의 지연 이동을 효과적으로 모사하기 위하여 3차원 지하수 유동 모델과 반응성 용질 이동 모델을 활용하였다. 모사 결과, $pCO_2=10^{-3.6}$조건에서 대부분의 우라늄 흡착(최대 99.5%)은 pH 5.5와 띠에서 발생하였다. $pCO_2$가 $10^{-2.5}$인 경우 우라늄이 대부분 흡착되는 pH범위는 6에서 7사이로 매우 좁았으며, 반면 $pCO_2=10^{-4.5}$인 경우에는 흡착되는 pH가 범위가 상대적으로 넓어 pH 5.5에서 8.5사이에서 대부분 흡착되었다. 음이온 화합물을 고려한 경우에는 pH 6 이하에서는 불소착물의 형성에 의해 우라늄 흡착이 감소하였다. 본 연구를 통하여, 우라늄 이동이 pH, $pCO_2$ 및 음이온의 종류와 농도 등 지하수의 지화학적 조건에 의해 상당히 영향을 받음을 알 수 있었다. 향후 여러 부지 조사 및 평가와 관련하여 우라늄 및 기타 유해성 화합물의 환경 영향을 예측하는데 있어 지구화학 모델이 중요한 도구로 활용되어야 할 것이다. In this study, the speciation, adsorption, and transport of uranium in groundwater environments were simulated using geochemical models. The retarded transport of uranium by adsortption was effectively simulated using 3-D groundwater flow and reactive transport models. The results showed that most uranium was adsorbed(up to 99.5%) in a neutral pH(5.5<pH<8) under low $pCO_2(10^{-3.6}atm)$ condition. Under the higher $pCO_2(10^{-2.5}atm)$ condition, however, the pH range where most uranium was absorbed was narrow from 6 to 7. Under very low $pCO_2(10^{-4.5}atm)$ condition, uranium was mostly absorbed in the relatively wide pH range between 5.5 and 8.5. In the model including anion complexes, the uranium adsorption decreased by fluoride complex below the pH of 6. The results of this study showed that uranium transport is strongly affected by hydrochemical conditions such as pH, $pCO_2$, and the kinds and concentrations of anions($Cl^-$, ${SO_4}^{2-}$, $F^-$). Therefore, geochemical models should be used as an important tool to predict the environmental impacts of uranium and other hazardous compounds in many site investigations.
二段冷却과 Ms溫度以下에서 恒溫維持에 依한 二相組織鋼의 機械的 性質의 改善에 關한 硏究
崔秉濚,李成載 전북대학교 공업기술연구소 1984 工學硏究 Vol.15 No.-
The improvement of mechanical properties in dual phase steels by two step cooling and isothermal holding below Ms temperature was studied. The experimental results obtained are summarized as follows : 1. Optimum mechanical properties in dual phase steels were obtained by two step cooling Mn-Si steels from 790℃(holding time : 2min). 2. During primary cooling of two step cooling the transformation of ferrite resulted in dispersion of martensite. 3. As a result of isothermal holding below Ms temperature, the volume fraction of retained austenite increased. 4. In case of isothermal holding at 350℃ or 400℃, yield point phenomena appeared due to smaller volume fraction of martensite. 5. With isothermal holding at 300℃, continuous yielding appeared because the volume fraction of martensite was above critical value. 6. Two types of retained austenite were observed by transmission electron microscope.
低炭素 dual Phase 鋼의 마르텐사이트 組織과 機械的 性質에 關한 硏究
崔秉泳 전북대학교 공업기술연구소 1982 工學硏究 Vol.12 No.-
A study has been made on the effect of martensite volume fraction, martensite morphology on the mechanical properties of low carbon dual phase steel(AISI 1020). In order to obtain both high strength and good formability, the following heat treatment were applied ; intermediate quenching, intercritical annealing and step quenching under the condition of various intercritical temperature. Experimental results showed as follows ; 1. Martensite volume fraction was increased in linear proportions with inercritical temperatures. 2. The yield and tensile strength were increased in linear with increasing martensite volume fraction. 3. In case of intermediate quenching, the value of σ_Y․S σ_U․T․S ration was the lowest and showed the largest elongation. These results showed good formability due to fine martensite morphology and discontinuous distribution of martensite particles in the ferrite matrix.
지구화학 모델을 이용한 장기간의 강알칼리성 지하수-암석의 반응 개념 모델링
최병영,류시원,장광수,김건영,고용권,최종원,Choi, Byoung-Young,Yoo, Si-Won,Chang, Kwang-Soo,Kim, Geon-Young,Koh, Yong-Kwon,Choi, Jong-Won 한국방사성폐기물학회 2007 방사성폐기물학회지 Vol.5 No.4
본 연구에서는 핵폐기물 매립장의 인공 방벽으로 사용되는 시멘트 물질들과 주변 지하수 반응 결과로 형성되는 강알칼리성 지하수와 주변 암과의 반응을 통해 변화되는 지하수 특성을 지구화학 모델링을 통해 예측하고자 하였다. 연구 결과 시멘트 수화반응을 통해서 pH는 13.3를 나타내었으며 이때 생성되는 광물들은 Brucite, Katoite, Calcium Silicate Hydrate(CSH 1.1), Ettringite, Hematitie, Portlandite였다. 이들 광물들과 경주 지역에서 채취된 지하수의 반응 모델링에서는 지하수의 pH가 12.4로 예측되었다. 이러한 강알칼리성 지하수와 주변 화강암과의 반응은 $10^3$ 년 동안 반응속도 모델링을 통해 모사하였다. 그 결과 지하수의 최종 pH는 11.2였으며 pH는 규산염 광물과 CSH 광물들의 용해 침전에 의해 조절되고 있었다. 또한 지하수 수질도 이들 광물들과 점토광물 및 산화광물들의 용해 침전에 의해 결정되고 있었다. 본 연구 결과는 장기간 동안의 강알칼리성 지하수와 주변 암과의 반응 모델링을 통해 지구화학 및 수질 변화를 예측함으로서 인공 방벽의 안정성 평가에 기여할 수 있을 것으로 판단된다.