리저버 탱크의 Die Turning Injection 적용을 위한 Multi-field CAE 해석 = A multi-field CAE analysis for die turning injection application of reservoir fluid tank

다국어 초록 (Multilingual Abstract)

In this study, die turning injection(DTI) mold design for manufacturing reservoir fluid tanks used for cooling in-vehicle batteries, inverters, and motors was conducted based on multi-field CAE. Part design, performance evaluation, and mold design of the reservoir fluid tank was performed. The frequency response characteristics through modal and harmonic response analysis to satisfy the automotive performance test items for the designed part were examined. Analysis of re-melting characteristics and structural analysis of the driving part for designing the rotating die of the DTI mold were performed. Part design was possible when the natural frequency performance value of 32Hz or higher was satisfied through finite element analysis, and the temperature distribution and deformation characteristics of the part after injection molding were found through the first injection molding analysis. In addition, it can be seen that the temperature change of the primary part greatly influences the re-melting characteristics during the secondary injection. The minimum force for driving the turning die of the designed mold was calculated through structural analysis. Hydraulic system design was possible. Finally, a precise and efficient DTI mold design for the reservoir fluid tank was possible through presented multi-field CAE process.

참고문헌 (Reference)

1 정수진, "다구치 법을 통한 다이슬라이드식 사출성형의 공정파라미터 최적화" 한국화학공학회 50 (50): 264-269, 2012

2 W. R. Jong, "Using a Visualization Mold to Discuss the Influence of Gas Counter Pressure and Mold Temperature on the Fountain Flow Effect" 33 (33): 255-267, 2018

3 L. N. Shafigullin, "Usage of polymeric fuel tanks in the automotive industry" 1-3, 2018

4 H. J. Lee, "The die turning injection(DTI)process for the fabrication of hollow parts" 212 : 808-816, 2012

5 Trieu Khoa Nguyen, "Numerical Investigation of Warpage in Insert Injection- Molded Lightweight Hybrid Products" 한국정밀공학회 18 (18): 187-195, 2017

6 M. Kurt, "Experimental investigation of plastic injection molding : Assessment of the effects of cavity pressure and mold temperature on the quality of the final products" 30 (30): 3217-3224, 2009

7 G. J. Bex, "Effect of process parameters on the adhesion strength in two component injection molding of thermoset rubbers and thermoplastics" 135 (135): 1-8, 2018

8 S. J. A. Rizvi, "Effect of injection molding parameters on crystallinity and mechanical properties of isotactic polypropylene" 21 : 404-426, 2017

9 Y. Murata, "Development of Mold for Demolding Resistance Measurement in Polymer Injection Molding" 31 (31): 3099-3110, 2019

10 A. Patila, "An overview of Polymeric Materials for Automotive Applications" 4 (4): 3807-3815, 2017