http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
무주지역 소유역내 지표수와 지하수의 안정동위원소 조성의 시공간적 변화
한원식,우남칠,이광식,이기철 대한자원환경지질학회 2003 자원환경지질 Vol.36 No.5
이 연구는 무주군 적상산 부근에 위치하는 소유역(100$Km^2$)에서 지표수와 천부 지하수의 안정동위원소 조성의 시공간적 변화를 조사하기 위해서 실시되었다. 시료채취는 2001년 8월(여름)과 10월(가을), 2002년 4월(봄), 3회에 걸쳐 실시되었다. 지표수의 동위원소 조성은 계절에 따라 뚜렷이 구분되어 도시되지만 천부 지하수에서는 이러한 변화가 줄어든 것이 관찰되었다. 하지만 지표수와 지하수의 안정동위원소 조성의 변화 폭은 계절별로 서로 유사하게 나타나고 있다. 이것은 이 지역에서 강수, 지표수 및 지하수 사이의 상호작용이 매우 활발하며 지속적으로 일어나고 있음을 의미한다. 무주지역 지표수의 안정동위원소 조성은 남쪽에 위치하는 섬진강의 조성보다는 가벼운 “위도효과”를 나타내고 있다. 또한 하천수에는 동위원소 조성의 계절변화와 아울러 강수의 “고도효과”와 “우량효과”가 잘 반영되어 있음이 관찰되었다. The purpose of this study is to identify the temporal and spatial variation of stable isotopic compositions of surface waters and shallow ground waters at a local watershed(100$Km^2$) near the Muju area. For oxygen and hydrogen isotope analysis, water samples were collected from 19-22 sites during August, October 2001, through April 2002. Seasonal variation in the isotopic compositions of surface waters was clearly shown. However, the degree of such isotopic variation was highly attenuated in shallow ground waters because of mixing with preexisting ground waters. Isotope values of surface waters and ground waters were very similar in each season, indicating that precipitation/ground water/surface water interactions were very active and continuous in the watershed. Stable isotopic ratios of surface waters in the study area were lighter than those of the downstream reach of Geum River on south, indicating “latitude effect”. Both “altitude effect” and “amount effect” were also shown in the stable isotopic ratios of surface waters in the study area as well as seasonal variation of stable isotopes.
가역성을 갖는 도자기 복원용 무황변 우레탄 수지의 개발과 이를 이용한 도자기의 복원
한원식,박기정,임성진,이영훈,홍태기,위광철 한국문화재보존과학회 2010 보존과학회지 Vol.26 No.2
무황변 가역성 도자기 복원 재료를 위하여 우레탄을 제조하여 이용하였다. 이 저점도형 우레탄은 사용자가 강도 조절이 가능하도록 제조하였다. 이 우레탄 복원재는 매우 강한 접착 강도와 전단 강도를 나타내고 있으며, 그간 일반적으로 사용되어온 에폭시 복원재와 같은 충진성, 수축성, 도색성을 갖도록 제조되었다. 특히, 현재 일반적으로 사용되는 에폭시계 복원재의 문제점인 황변 현상과 비가역성 문제를 해결함으로서, 도자기의 복원의 항구성과 지속적인 안정성을 부여할 수 있을 것으로 보인다. 또 본 우래탄 복원재를 이용하여 도자기를 직접 적용 복원하였으며 복원 후, 이를 재 용해하여 복원제를 완벽히 제거하는 과정을 통하여 복원의 가역성도 보이고자 하였다.
석조문화재 복원용 우레탄 메움제 및 접착제에 관한 연구
한원식,이호연,박기정,홍태기,위광철 한국문화재보존과학회 2011 보존과학회지 Vol.27 No.1
석조 문화재의 복원을 위하여 우레탄 복원제를 제조하였다. 제조된 우레탄 복원제는 그간 석조 문화재 복원용 재료로 주로 사용해 왔던 에폭시계 복원제 정도의 강한 접착 강도와 인장 강도를 나타내고 있으며, 충진성, 수축성, 도색성 등의 물성 역시 에폭시계 복원제와 유사하게 제조되었다. 특히, 이 우레탄 복원제는 그간 가장 큰 문제점으로 대두되었던 에폭시계 복원제의 황변 현상과 비가역성 문제를 해결함으로서, 석조문화재의 복원의 항구성과 지속적인 안정성을 부여할 수 있을 것으로 보인다. 또 본 복원제를 메움제와 접착제로 직접 적용하여 사용하였으며, 이를 재 용해하여 복원에 사용된 우레탄을 제거할 수 있어 본 복원제의 가역성을 나타내었다. 이 복원제는 작업 환경에 따라 복원자가 가사 시간을 조정할 수 있도록 제조되어 사용의 편리성 또한 증진시켰다. 또 이 복원제는 강한 접착력과 인장 강도를 가지고 있어 석조문화재 이외의 도자기나 금속 문화재 등의 다양한 문화재의 메움제나 접착제로 사용이 가능할 것으로도 사료된다.
한원식,위광철,오승준,이영훈 한국문화재보존과학회 2018 보존과학회지 Vol.34 No.1
This study synthesized poly-urea and used it as a filler material for the restoration of porcelain. The synthesized poly-urea was manufactured as a resin and hardener mix that does not undergo contraction during curing, and is unfading. Given an adhesion strength of 180 kg/cm2 and shearing strength of 200 kg/cm2, the synthesized poly-urea exhibited the same efficacy as the epoxy putty currently sold in the market. Moreover, it also overcame the drawback of foaming encountered by urethane restoratives, which are a structurally similar type. The hardening time and pot life could also be controlled using additives. The poly-urea used for the restoration of modern artifacts presented a pot life of approximately one hour and took 12 h for complete hardening (T90). When a 2 × 2 × 2 cm-sized test sample was added to xylene, poly-urea started to separate approximately two hours later and completed perfect pulverization within the solution 24 h later, demonstrating its reversibility. When directly applied to contemporary artifacts, it demonstrated the potential for restoration, as well as convenience and colorfulness. 도자기 복원을 위한 폴리우레아를 합성하여 메움제로 제조한 후 이를 도자기 보존 처리과정에 필요한 성형에 적용하였다. 합성된 폴리우레아는 이액 반응형 경화 재료로 경화되는 과정에서 수축이 없고 무황변 소재로 제조되었다. 180 kg/cm2의 접착 강도와 200 kg/cm2의 전단 강도를 비교하여 볼 때, 기존의 시판 에폭시 퍼티의 수준으로 제조되었으며, 구조상 유사 형태인 우레탄 복원제의 문제점으로 지적되었던 기포가 발생하지 않았으며 경화 시간과 가사 시간도 첨가되는 반응 촉매의 량에 따라 조절할 수 있었다. 현대 유물 복원에 사용된 조성의 폴리우레아의 경우 가사 시간 약 1 시간, 완전 경화 시간 (T90) 12 시간 정도를 나타내고 있었으며 2 × 2 × 2 cm 크기의 시편을 xylene에 첨가하였을 때 약 2 시간 후에서부터 분리가 시작되어 24 시간 후에는 용액 내에서 완전 분말화가 이루어져서 가역성을 나타내고 있었고 이를 직접 현대 유물에 적용하여 복원 가능성과 편리성, 채색성 등을 나타내는 것을 확인하였다.
한원식,김영욱,이상호,장감용,이준근 한국세라믹학회 1985 한국세라믹학회지 Vol.22 No.4
The subcritical crack growth of sintered SiC is investigated under various corrosive atmospheres such as distilled water Murakami solution and saturated KOH solution. The KI-V diagrams are obtained by the load relaxation method and incremental displacement rate method using the double torsion technique. The obtained fracture mechanics parameters (n) of sintered SiC are 79 in Murakami solution and 39 in saturated KOH solution. These data indicate that the subcritical crack growth of sintered SiC is taking place in these two conditions and the stress-corrosion cracking is suggested to be the mechanism. With these KI-V diagrams the life of sintered SiC in these conditions is predicted.